14
Viewing and editing group properties
Viewing and editing group properties
To view encryption group properties, complete the following steps.
1. Select Configure > Encryption.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
3. Select a group from the Encryption Devices table, and select Group > Properties from the
NOTE
The Link Keys tab appears only if the key vault type is NetApp LKM.
FIGURE 177
430
The Encryption Center dialog box displays.
bar.
The encryption groups display in the Encryption Devices table.
menu bar, or right-click the group and select Properties.
The Encryption Group Properties dialog box, shown in
defined in this section:
•
"General tab"
on page 431
•
"Members tab"
on page 431
•
"Security tab"
on page 434
•
"HA Clusters tab"
on page 435
•
"Engine Operations tab"
•
"Link Keys tab"
on page 436
•
"Tape Pools tab"
on page 437
Encryption Group Properties dialog box
Figure
on page 435
176, has six tabs which are
DCFM Professional User Manual
53-1001773-01