Adding A Property Label - HP Brocade BladeSystem 4/12 User Manual

TABLE 6
Field/Component
Slot #
Source IP Address
Speed (Gb/s)
State
Status
Switch Name
Switch IP
Switch WWN
Tape Pipelining
Tunnel ID
Type
Unit Type
Vendor
# Virtual FCoE port count
VLAN #
VLAN Class of Service for Control
Connection
VLAN Class of Service for Data
Connection
VLAN ID
WWN

Adding a property label

You can add a new field to any of the tabs on the Properties dialog box.
To add a new field, complete the following steps.
1. Right-click any product icon and select Properties.
2. Select the tab to which you want to add a property.
3. Right-click on any label.
4. Select Add.
5. Type a label and description for the property.
6. Select the property type from the Type list, if available.
DCFM Professional User Manual
53-1001773-01
Device properties
The Properties dialog box displays.
The new property label displays above the one you select.
The Add Property dialog box displays.
Description
The slot number of the trunk.
The IP address of the of the FCIP tunnel source device.
The speed of the port in gigabytes per second.
The device's state, for example, online or offline.
The operational status.
The switch name.
The switch IP address.
The switch world wide name.
Whether tape pipelining is On or Off for the FCIP tunnel.
The tunnel identifier.
The device type.
The unit type of the node.
The product vendor.
The number of virtual FCoE ports on the device. There is a one-to-one
mapping of TE ports to virtual FCoE ports. Therefore, the number of
virtual session ports is one for directly connected devices.
The VLAN number of the FCIP tunnel.
The VLAN class of service for the control connection of the FCIP tunnel.
The VLAN class of service for the data connection of the FCIP tunnel.
The VLAN identification number.
The world wide name of the device.
7
Device properties
135