Enabling A Cee Port Or Lag - HP Brocade BladeSystem 4/12 User Manual

Enabling a CEE port or LAG

If you select multiple switches or multiple ports and LAGs from two or more switches, both the
Enable button and the Disable button are disabled.
1. Select Configure > Switch > CEE from the menu bar.
2. Select one or more CEE ports or LAGs (which can span multiple switches) that you want to
3. Click Enable.
4. Click OK.
5. Review the changes carefully before you accept them.
6. Click Start to apply the changes, or click Close to abort the operation.
DCFM Professional User Manual
53-1001773-01
NOTE
If the primary or secondary IP address already exists on another interface, an error message
displays in the Status area.
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
enable.
NOTE
All selected LAGs must be in the same state (enabled or disabled); otherwise, both the Enable
and Disable buttons are disabled.
The selected CEE port or LAG is enabled for CEE configuration.
The CEE Confirmation and Status dialog box displays.
The selected CEE port or LAG is enabled for CEE configuration. (The Status column in the CEE
Configuration dialog reflects the change).
Link aggregation groups
13
303