HP Brocade BladeSystem 4/12 User Manual page 454

14
Encryption Targets dialog box
FIGURE 175
TABLE 22
Feature
Add button
Remove button
Move button
422
Encryption Targets dialog box
Description
Launches the Storage Encryption Setup Wizard, which enables you to
configure a new target for encryption. It is the first step in configuring
encryption for a storage device.
It is recommended that you zone the host and target together before you
add container information.
•
Note:
•
•
Removes a selected target. Proceed only if the data on the LUN is to be
disabled or if the LUN is to be configured for encryption again on some
other encryption engine. If the LUN data is to be enabled and later
accessed by way of another encryption engine, you should unzone the
host with the encryption engine before you remove the encryption target
from the encryption engine. This prevents the host from accidentally
writing to the encryption target during the unencrypted interim period.
Moves one encryption target to a different encryption engine. The target
and engine must be in the same encryption group.
Note: If the group is in OK-Converged mode, the group leader can
communicate with all members. The Configure Storage Encryption
wizard dialog box launches when you click Add.
If a group is in the Degraded state, the following operations are not
allowed: key vault changes, master key operations, enable/disable
encryption engines, failback mode changes, HA Cluster creation or
addition (removal is allowed), tape pool changes, and any
configuration changes for storage targets, hosts, and LUNs.
If a group is in the Unknown state, the group leader is in an
unmanaged fabric.
CAUTION
Removing a selected target can result in data loss, if
the host is writing to the target as it is removed.
Removing the target will result in lost access to the
data, but the data remains encrypted on the target.
DCFM Professional User Manual
53-1001773-01