Activating A Zone Configuration - HP Brocade BladeSystem 4/12 User Manual

4. Select one or more zone configurations to which you want to add zones in the Zone Configs
5. Select one or more zones to add to the zone configurations in the Zones list. (Press SHIFT or
6. Click the right arrow between the Zones list and Zone Configs list to add the zones to the zone
7.

Activating a zone configuration

For FC fabrics and router fabrics, when a zone configuration is active, its members can
communicate with one another. Only one zone configuration can be active at any given time.
When you initiate activation of a zone configuration, a number of checks are performed on the
zone configuration. These checks are performed before the Activate Zone Config dialog box is
displayed, and look for the following problems:
•
•
•
For pure EOS fabrics, during zone configuration activation, the total number of zone members in
each zone and in the zone configuration are checked against the limits imposed by the firmware
and hardware product. If the limits are exceeded, a message is displayed informing you of the
exceeded limits as well as the zone configuration failure information. Click OK to close the
message box, and take appropriate action to meet the limits. For FC fabrics, this calculation is not
done during activation, but a message is displayed whenever the size of the zone database
exceeds the limits imposed by the switch.
When a zone configuration is activated, the entire zone database is sent to the fabric, except for
McDATA Open Mode (Interop Mode 3) or a pure M-EOS fabric, when only the active configuration
information is sent to the fabric.
NOTE
Only one server should be run at a time (actual servers performing discovery) or logon conflicts may
occur. Also, activation speeds may differ depending on the hardware vendor and type of zoning
used.
There are several conditions that could cause the Activate button to be unavailable. They include
the following:
DCFM Professional User Manual
53-1001773-01
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
list. (Press SHIFT or CTRL and click each zone configuration name to select more than one
zone configuration.)
CTRL and click each zone name to select more than one zone.)
configurations.
Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making
changes to the same areas.
Zone and zone configuration name violations
Zoning configuration violations
Zone configuration change limit violations
•
If you do not have access privileges to activate zone configurations, the Activate button on
the Zone DB tab will be unavailable. You will not be able to activate a zone configuration
unless your access privileges are redefined.
•
The fabric is not manageable.
Zoning configuration
15
455