Ip Troubleshooting; Configuring Ip Ping - HP Brocade BladeSystem 4/12 User Manual

16

IP troubleshooting

3. Click OK.
4. Click Re-run Diagnosis to run the device connectivity on the same ports.
5. Click Trace Route to trace the route between the two selected ports.
6. Click Close on the Device Connectivity Troubleshooting Results dialog box.
Adding a detached device
To add a detached device to the Selected Device Ports table, complete the following steps.
1. Select Configure > FC Troubleshooting > Device Connectivity.
2. Click Add Detached.
3. Enter the port WWN of the detached device port in the Port WWN field.
4. Click OK.

IP troubleshooting

NOTE
IP troubleshooting is only available for Fabric OS devices.
You can perform the following operations using IP troubleshooting:
•
•
•

Configuring IP ping

NOTE
IP Ping only supported on Fabric OS devices running Fabric OS 5.2 or later.
To configure IP ping, complete the following steps.
482
The following diagnostic tests are performed:
•
Device Status
•
Switch port health status
•
Zone configuration in the fabric
•
Edge fabric - FC router physical connection status.
•
Active ACL DCC policy check (Fabric OS only)
The Device Connectivity Troubleshooting Results dialog box displays.
If no problems are found, the diagnostic test is marked with a check mark. If problems are
found, an alert icon appears next to the test, with a brief statement detailing the error as well
as a suggested resolution.
The Device Connectivity Troubleshooting dialog box displays.
Ping. Use to confirm that the configured FCIP tunnels are working correctly.
Trace Route. Use to view the route information from a source port on the local device to a
destination port on another device and determine where connectivity is broken.
Performance. Select to view FCIP tunnel performance between two devices.
DCFM Professional User Manual
53-1001773-01