Duplicating A Security Violation Policy - HP Brocade BladeSystem 4/12 User Manual

8
Event policies
11. Select the Active check box to activate the duplicated policy.
12. Click OK on the Event Policies dialog box.

Duplicating a security violation policy

To duplicate a security violation policy, complete the following steps.
1. Select Monitor > Event Policies.
2. Select the policy you want to duplicate in the Policies table.
3. Click Duplicate.
4. Enter a name (255 characters maximum) for the policy in the Name field.
5. Define the trigger in the IP Address, Node WWN, and Name list.
6. Enter a value (between 2 and 999) in the Count field.
7.
8. Select the duration type (Seconds or Minutes) from the Duration list.
9. Select the check box in the Actions list for each action you want to occur when this policy is
10. Click OK on the Add Event Policy dialog box.
11. Select the Active check box to activate the duplicated policy.
12. Click OK on the Event Policies dialog box.
196
The Event Policies dialog box displays.
The Duplicate Event Policy dialog box displays.
Policy names must be unique; however, they are case insensitive.
The trigger is limited to 1024 characters. Multiple values must be separated by a semi-colon.
When multiple values are entered, as long as at least one value matches the IP address, Node
WWN, or Name in the event and all other conditions are met, an action is triggered.
IP addresses can either be in IPv4 or IPv6 format and must be complete.
A Node WWN is accepted with or without the colon.
Enter a value (between 1 and 999) in the Duration field.
The maximum duration is 30 minutes.
triggered.
For a list of the available actions, refer to
refer to "Defining the broadcast message action"
action" on page 190, "Defining the send e-mail action"
data capture action" on page 192.
"Policy actions" on page 185. To define an action,
on page 189, "Defining the launch script
on page 191, or
DCFM Professional User Manual
"Configuring support
53-1001773-01