Storm-Constrain Interval - HP 6125XLG Command Reference Manual

Default
An interface sends out traps when monitored traffic exceeds the upper threshold or falls below the lower
threshold.
Views
Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable Ten-GigabitEthernet 1/1/5 to send traps when it detects storm control threshold events.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] storm-constrain enable trap

storm-constrain interval

Use storm-constrain interval to set the traffic polling interval of the storm control module.
Use undo storm-constrain interval to restore the default.
Syntax
storm-constrain interval seconds
undo storm-constrain interval
Default
The storm control module polls traffic statistics every 10 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
seconds: Sets the traffic polling interval of the storm control module, in the range of 1 to 300 seconds.
Usage guidelines
The interval set by the storm-constrain interval command is specific to storm control. To set the statistics
polling interval of an interface, use the flow-interval command.
For network stability, use the default or a higher polling interval.
Examples
# Set the traffic statistics polling interval of the storm control module to 60 seconds.
<Sysname> system-view
[Sysname] storm-constrain interval 60
Related commands
• storm-constrain
31