Qinq Transparent-Vlan - HP 6125XLG Command Reference Manual

Syntax
qinq ethernet-type service-tag hex-value
undo qinq ethernet-type service-tag
Default
The SVLAN TPID is 0x8100.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
hex-value: Sets a hexadecimal TPID value in the range of 0x0001 to 0xFFFF, excluding the common
protocol type values listed in
Usage guidelines
TPID identifies a frame as an 802.1Q tagged frame.
A service provider-side port uses the SVLAN TPID to re-mark the TPID in outgoing frames' SVLAN tags, in
addition to matching incoming tagged frames.
Examples
# Set the SVLAN TPID to 0x9100 on FortyGigE 1/1/1.
<Sysname> system-view
[Sysname] interface fortygige 1/1/1
[Sysname-FortyGigE1/1/1] qinq ethernet-type service-tag 9100

qinq transparent-vlan

Use qinq transparent-vlan to configure transparent transmission for a list of VLANs on a QinQ-enabled
port, so the port transmits frames from the specified VLANs without performing QinQ tagging.
Use undo qinq transparent-vlan to remove the transparent transmission configuration for a list of VLANs
on a port.
Syntax
qinq transparent-vlan vlan-list
undo qinq transparent-vlan { vlan-list | all }
Default
Transparent transmission is not configured for any VLAN on a port.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Table 35.
166