HP 6125XLG Command Reference Manual page 45

Field
Last 300 seconds output: 0
bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
# Display brief information about all loopback interfaces.
<Sysname> display interface loopback brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Loop1
# Display brief information about all existing loopback interfaces, including the full description of each
loopback interface.
<Sysname> display interface loopback brief description
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Loop1
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Table 9 Command output
Field
The brief information of interface(s)
under route mode:
Link: ADM - administratively down;
Stby - standby
Protocol: (s) – spoofing
Interface
Description
Average output rate over the last 300 seconds (displayed when the
interface supports traffic statistics collection):
•
packets/sec—Average number of packets sent per second.
•
bytes/sec—Average number of bytes sent per second.
•
bits/sec—Average number of bits sent per second.
Amount of incoming traffic in packets and in bytes, and the total
number of dropped incoming packets (displayed when the interface
supports traffic statistics collection).
Total number and size (in bytes) of output packets of the interface and
the number of dropped packets (displayed when the interface supports
traffic statistics collection).
Link Protocol Main IP
UP UP(s) --
Link Protocol Main IP
UP UP(s) --
Description
Brief information about loopback interfaces.
•
ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
•
Stby—The interface is a standby interface.
If the data link layer protocol of an interface is up but its link is an
on-demand link or not present at all, this field displays UP (s), where s
represents the spoofing flag. This attribute is typical of interface Null 0
and loopback interfaces.
Interface name.
38
Description
aaaaaaaaaaaaaaaaaaaaaaaaaaa
Description
aaaaaaaaaaaaaaaaaaaaaaaaaaaaa