Storm-Constrain Control - HP 6125XLG Command Reference Manual

When configuring this command, make sure upperlimit is greater than lowerlimit.
Examples
# Enable unknown unicast storm control on Ten-GigabitEthernet 1/1/5, setting the upper and lower
thresholds to 200 pps and 150 pps.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] storm-constrain unicast pps 200 150
# Enable broadcast storm control on Ten-GigabitEthernet 1/1/6, setting the upper and lower thresholds
to 2000 kbps and 1500 kbps.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/6
[Sysname-Ten-GigabitEthernet1/1/6] storm-constrain broadcast kbps 2000 1500
# Enable multicast storm control on Ten-GigabitEthernet 1/1/7, setting the upper and lower thresholds
to 80% and 15%.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/7
[Sysname-Ten-GigabitEthernet1/1/7] storm-constrain multicast ratio 80 15
Related commands

storm-constrain control

•
storm-constrain interval
•
storm-constrain control
Use storm-constrain control to set the protective action to take on an Ethernet interface when a type of
traffic (unknown unicast, multicast, or broadcast) exceeds the upper storm control threshold.
Use undo storm-constrain control to restore the default.
Syntax
storm-constrain control { block | shutdown }
undo storm-constrain control
Default
No action is taken on an Ethernet interface when a type of traffic exceeds the upper storm control
threshold.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
block: Blocks this type of traffic, while forwarding other types of traffic. Even though the interface does
not forward the blocked traffic, it still counts the traffic. When the blocked traffic is detected dropping
below the lower threshold, the port begins to forward the traffic.
shutdown: Shuts down automatically. The interface shuts down automatically and stops forwarding any
traffic. When the blocked traffic is detected dropping below the lower threshold, the port does not
29