Port-Isolate Group - HP 6125XLG Command Reference Manual

Syntax
port-isolate enable group group-number
undo port-isolate enable
Default
No ports are assigned to an isolation group.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
group group-number: Specifies an isolation group by its number in the range of 1 to 8.
Usage guidelines
The configuration in Ethernet interface view applies only to the interface.
The configuration in aggregate interface view applies to the aggregate interface and its aggregation
member ports. If the device fails to apply the configuration to the aggregate interface, it does not assign
any aggregation member port to the isolation group. If the failure occurs on an aggregation member
port, the device skips the port and continues to assign other aggregation member ports to the isolation
group.
You cannot assign the member ports of a service loopback group to an isolation group, and vice versa.
Make sure the isolation group specified in the command already exists.
Examples
# Assign ports Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 to isolation group 2.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5 port-isolate enable group 2
[Sysname-Ten-GigabitEthernet1/1/5] quit
[Sysname] interface ten-gigabitethernet 1/1/6
[Sysname-Ten-GigabitEthernet1/1/6] port-isolate enable group 2
Related commands
display port-isolate group

port-isolate group

Use port-isolate group to create an isolation group.
Use undo port-isolate group to delete isolation groups.
Syntax
port-isolate group group-number
undo port-isolate group { group-number | all }
Default
No isolation group exists.
92