HP 6125XLG Command Reference Manual page 14

Loopback is not set
Media type is not sure,Port hardware type is No connector
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 10000
Allow jumbo frame to pass
Broadcast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Unicast MAX-ratio: 100%
PVID: 1
Port link-type: access
Tagged Vlan: none
UnTagged Vlan: 1
Port priority: 0
Last clearing of counters: Never
Peak value of input: 0 bytes/sec, at 2011-01-01 22:10:43
Peak value of output: 0 bytes/sec, at 2011-01-01 22:10:43
Last 300 seconds input:
Last 300 seconds output:
Input (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 3 Command output
Field
Ten-GigabitEthernet 1/1/5 current state
IP Packet Frame Type
0 packets/sec 0 bytes/sec -%
0 packets/sec 0 bytes/sec -%
Description
State of the Ethernet interface:
•
Administratively DOWN—The Ethernet interface was shut down
with the shutdown command. The interface is administratively
down.
•
DOWN—The Ethernet interface is administratively up but
physically down (possibly because no physical link is present or
the link has failed).
•
UP—The Ethernet interface is both administratively and
physically up.
Ethernet frame format. The value PKTFMT_ETHNT_2 indicates that
the Ethernet frame format is Ethernet II.
7