Duplex - HP 6125XLG Command Reference Manual

Field
Unit
CtrlMode
Status
Trap
Log
SwitchNum

duplex

Use duplex to set the duplex mode for an Ethernet interface.
Use undo duplex to restore the default duplex mode of the Ethernet interface.
Syntax
duplex { auto | full }
undo duplex
Default
The downlink 10-GE interfaces operate in full duplex mode, and all other types of Ethernet interfaces
operate in autonegotiation mode.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
auto: Configures the interface to autonegotiate the duplex mode with the peer.
full: Configures the interface to operate in full duplex mode, so that the interface can receive and transmit
packets at the same time.
Usage guidelines
Downlink 10-GE interfaces support only the full keyword of the command.
Description
Storm control threshold unit:
•
pps.
•
kbps.
•
percentage.
Protective action (block or shutdown) taken on the port when the upper
threshold is reached. N/A indicates that no protective action is configured.
Packet forwarding status:
•
forwarding—The port is forwarding traffic correctly.
•
shutdown—The port has been shut down.
•
block—The port drops the type of traffic.
Status of the storm control threshold event trap switch:
•
on—The port sends threshold event traps.
•
off—The port does not send threshold event traps.
Status of the storm control threshold event log switch:
•
on—The port sends threshold event log messages.
•
off—The port does not send threshold event log messages.
Number of forwarding state changes of the interface.
When the SwitchNum count reaches 65535, it resets automatically.
16