Link-Delay - HP 6125XLG Command Reference Manual

Examples
# Enable jumbo frames to pass through Ten-GigabitEthernet 1/1/5.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] jumboframe enable

link-delay

Use link-delay to set the physical state change suppression interval on an Ethernet interface.
Use undo link-delay to restore the default.
Syntax
link-delay delay-time [ mode { up | updown } ]
undo link-delay
Default
Each time the physical link of an interface goes up or comes down, the interface immediately reports the
change to the CPU.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
delay-time: Sets the physical state change suppression interval (in seconds) on the Ethernet interface. The
value range for this argument is 0 to 30. A value of 0 indicates that physical state changes are not
suppressed.
mode up: Suppresses the link-up events.
mode updown: Suppresses both the link-up and link-down events.
Usage guidelines
With the link-delay delay-time command configured:
• When the interface comes down, the link-down event is not reported to the CPU unless the interface
is still down when the suppression interval (delay-time) expires.
When the interface goes up, the link-up event is immediately reported.
•
With the link-delay delay-time mode up command configured:
When the interface goes up, the link-up event is not reported to the CPU unless the interface is still
•
up when the suppression interval (delay-time) expires.
When the interface comes down, the link-down event is immediately reported.
•
With the link-delay delay-time mode updown command configured, when the interface comes down or
goes up, the link-down or link-up event is not reported to the CPU unless the interface is still down or up
when the suppression interval (delay-time) expires.
On a port, if you configure the link-delay command multiple times, the most recent configuration takes
effect.
20