Oce Arizona 200 GT User Manual page 118

How to Unload and Cut Media
C: Remove Media from the Take-up Shaft in Printer or Remove Take-up Shaft
If there are only a few images on the take-up roll and you want to remove them
1.
without removing the take-up roll from the printer you can press the left pedal to
rotate the take-up media shaft in the reverse direction. You can then roll up the media
by hand as comes off the take-up roll.
The other option is remove the take-up roll from the printer and then remove the roll
2.
of unused media from the media shaft. To remove the take-up roll, tap the right pedal
momentarily to rotate the take-up shaft one revolution to the unlocked position in the
forward direction.
D: Remove the Supply Shaft From the Printer
If you want to change the supply shaft, momentarily press the left pedal to rotate the
1.
supply shaft four complete revolutions. This rewinds excess media back onto the
supply roll if is not empty) to the unlocked position.
Remove the supply shaft from the printer by pulling it up and out of the drive coupler.
2.
E: Remove Media Roll Or Empty Core From the Media Shaft
Place the media shaft on a suitable work surface.
1.
Unlock the media shaft core locks using a 5 mm hex key.
2.
Slide the media core off the shaft.
3.
Result
Roll Media unit is now ready for you to load new media.
118 Chapter 6 How to Operate the Roll Media Option