How to Create Custom Vacuum Zones
[55]
[55] How to Handle the Overlay
With one hand on the top and the other on the bottom, carefully flip the overlay over
3.
and lay it down flat on the table (or another clean, flat surface).
Remove any old foam tape that is no longer required in the new configuration.
4.
Clean the area of the overlay sheet where the new foam tape is to be applied with
5.
isopropyl alcohol.
Measure and add tape (part # 3010106701: gray silicone foam tape) in the desired
6.
locations to create zones. When you create a zone we recommend that active vacuum
holes are a minimum of 15 mm from the outside edges of the media. This optimizes
the sealing effect between the media and the table.
92
Chapter 5 How to Operate the Arizona 200/250 GT