Oce Arizona 200 GT User Manual page 122

How to Print on Roll Media
Before you begin
Media must be loaded and initialized as explained in the section "How to Load Roll
Media".
Attention: The red Emergency stop buttons do NOT stop the media transport
when you print on roll media (they only stop gantry and carriage movement). If
you encounter a situation where the roll media runs continuously without
operator input, the only recourse is to shut off the printer's AC power switch.
Prepare a Roll Media Print Job
Click on the Roll icon in the menu bar of the Job Control module to disable the RMO
1.
print queue (this allows you to check media parameters before the job actually prints
in case the job was not given a Hold status when it was generated in Onyx
ProductionHouse).
[70]
[70] Roll Icon
In the Print Job Control module, transfer a print job from Onyx ProductionHouse.
2.
Click on the Roll Manager icon to enter the Roll Media Manager dialog window.
3.
Check that the media parameters displayed match the particular media you are using.
4.
You can create a new media or edit an existing one by changing the parameter values
5.
and then saving them under a new media name. When you create a new media it
takes the current values as default and automatically creates a unique media name
based on the existing name. You can change the assigned name by selecting
characters from the virtual keyboard.
Note: Any changed parameter in the dialog window will be applied to the next roll
media print job, even if the change was not saved. This allows temporary changes to
the parameters without the need to save that media.
122 Chapter 6 How to Operate the Roll Media Option