Oce Arizona 200 GT User Manual page 150

Printhead Maintenance
Switch 1 to purge ink
1.
Switch 2 to raise carriage
2.
Switch 3 to activate suction pump
3.
Illustration
[78]
[78] Maintenance Station Switches
How To Perform Maintenance
Verify that the ink temperature is at least 40° Centigrade (140° Fahrenheit) before
1.
you begin printhead maintenance.
Slide the cover out from under the carriage to reveal the maintenance station.
2.
Press and release switch 1 to initiate a purge. The carriage will lower to its purge
3.
height (4mm above the table surface). Watch the ink as it falls from the heads. After
a few seconds most of the ink stops dripping and you can then raise the carriage.
Press switch 2 to raise the carriage to its maximum height.
4.
Attention: Be careful not to snag the coiled suction-head hose when removing
the suction-head from the holder.
150 Chapter 10 Printer Maintenance