Oce Arizona 200 GT User Manual page 116

How to Load Media
Tape the media onto the core. The media should have a clean straight edge prior to
9.
taping. First tape the center of the media to the core, and then tape both ends of the
media.
[67]
[67] Tape Media to the Take-up Roll Core
Note: Ensure that the media is flat along the core. If the media is not flat it can
create an uneven roll that affects the motion of the media past the printheads and
therefore the quality of the image.
Use the supplied ruler to check that the take-up roll is centered within 1mm (or 5mm
10.
if you use the edge detection sensor).
D: Initialize Roll Media To Prepare For Printing
Select the "Initialize" icon from the Roll Media Manager to properly tension the
media and to prepare for printing.
E: Select Existing Or Create New Media Parameters
From the Roll Media Manager select the media to be printed on or create a new set
of media parameters for the media loaded. Refer to the Roll Media Manager section
for details.
Result
You are now ready to print. Refer to the How to Print on Roll Media section for
instructions
116 Chapter 6 How to Operate the Roll Media Option