Oce Arizona 200 GT User Manual page 114

How to Load Media
C: Thread the Media
Select the Load icon from the Roll Media Manager.
1.
If you are going to print with "Print Side In", click the icon in the Roll Media
2.
manager ("Print Side Out" is the default so you do not need to select it unless you
have recently used Print Side In). Note that the icon toggles from one choice to the
other when you click it.
Note: For Print Side Out, the media unrolls from the bottom the supply shaft as
shown in green on the left below.
For Print Side In, the media unrolls from the top of the supply shaft as shown in red
on the right below. This allows you to print on the "back" side of the media.
[63]
[63] Media Path Choices
Wait for the gantry to move part way across the table.
3.
Continually press on the right foot pedal, as required, to gradually advance the media
4.
for the next two steps.
Thread the media under the media tension bar (Note that the media is threaded for
5.
Print Side Out in the photo below).
[64]
[64] Thread Media Under Tension Bar (Print side out)
114 Chapter 6 How to Operate the Roll Media Option