Oce Arizona 200 GT User Manual page 175

Required tools
Blue LED view light (sometimes needed to enhance contrast in the Yellow area).
Océ I/O paper
Note: Usually, two or more Nozzle Checks will be printed to verify that nozzle issues
are resolved. To calculate the required offset when you print multiple consecutive
nozzle checks, add a horizontal offset of 2.5" or 60 mm to each consecutive print.
How to Print the Nozzle Check
Place a piece of Océ I/O paper on the printer table.
1.
Select the Nozzle Check icon at the right end of the Command Toolbar to place the
2.
nozzle check into the Active Print Job list (you can also add a Nozzle Check to the
active print list when you select it from the Special Prints module).
Modify the horizontal offset (only if a previous nozzle check was printed on the same
3.
piece of media).
Confirm media thickness.
4.
Activate the table vacuum.
5.
Push the printer Start button to begin the print.
6.
Check
The Magenta section of the Nozzle Check print shown in the figure below indicates
that multiple nozzles are out.
[88]
[88] Nozzle Check Print Magenta Section
Correction
To correct the nozzle dropout problem illustrated above, perform Printhead
1.
Maintenance Printhead Maintenance on the colors that show dropouts, and then print
the Nozzle Check again.
If the second Nozzle Check still shows nozzle dropouts, suction the printhead that
2.
still show nozzles out again.
If nozzle outs still remain, swab that printhead
3.
Print a Nozzle Check
(see 'Swab Printheads' on page 155).
175