Oce Arizona 200 GT User Manual page 63

[22]
Offsets
Print Parameters
10) Printer Interface Module Tabs
These tabs allow you to switch between different functional modules of the printer.
Click on a tab to display the screen associated with each of the modules available.
11) Software Version Number and Image Upload Progress
Displays the version of the currently installed printer software.
A job's vertical and horizontal offset parameters can be
changed with the mouse wheel when mouse cursor is
positioned over the field. Rotate the mouse wheel up or
down increments or decrements offset at the rate of one
unit per notch. Hold the right mouse button and rotate the
wheel increments or decrements at the rate of 10 units per
notch. An alternate method to change parameter values is
to click on the field and this brings up an onscreen
keyboard so you can click on the numbers required.
Displays information about the print job that is currently
selected:
Mode - Print quality mode: Select Production, Quality,
or Fine Art mode in ProductionHouse. When Quality
mode is set, this field will have a pull-down box that
allows you to select Quality-Matte or Quality-Density.
Quality-Matte provides a matte finish to the entire
image. This is helpful on some media such as
FomeCore, GatorPlast or Styrene as a glossy image
tends to have a matte line at the end of each swath with
these media. Quality-Matte resolves this issue.
Quality-Density provides more density for backlit
media. This is most useful when you print on roll
media, since Overprint is only possible on flatbed jobs.
Also for flatbed media that may warp or move slightly
from the heat of the lamps, the Density mode will
reduce that because it is done in one pass.
Direction - Bidirectional and Forward or Reverse
unidirectional printing
Overprints - If the Overprint count is set to greater
than 0 (zero), the printer will re-print the image again
on the same piece of media.
Copies - use the mouse to increase or decrease.
Type - Print Method - Flatbed or Roll.
Media - Media that was selected in ProductionHouse.
Notes - Appears only if a note was specified for the job.
Notes are entered in ONYX ProductionHouse.
Print Job Control Module
63