Oce Arizona 200 GT User Manual page 151

Press switch 3 to turn on the suction pump. Pick up the suction-head from the tray at
5.
the left end of the maintenance station. Wipe the suction-head with a new, clean
lint-free wipe to remove any particles that could damage the nozzles in the
printheads.
[79]
[79] Clean Suction-Head
Note: In the next step, start with the left printhead and work to the right as this limits
the possibility that drops of ink will fall onto the coiled hose. Also, do not push up
too hard on the printhead as you may dislodge it and this will require a service call
to fix.
Slide the suction-head slowly along the entire length of each printhead at a speed of
6.
approximately 8mm per second (8 seconds per printhead). The suction-head slides
on stainless steel strips on the printhead. Check to see that all ink is removed – repeat
if necessary.
[80]
[80] Swipe Printhead
Wipe the suction-head on a clean piece of new lint-free wipe before proceeding to
7.
the next printhead.
Printhead Maintenance
151