How to Load Media
Introduction
This section explains all of the actions associated with loading a new roll of media
when the Roll Media Option is installed. It also specifies in detail how to perform
particular actions.
Load Media
The following actions are associated with loading media:
A) Load Supply Media Roll On Media Shaft
B) Load Take-up Empty Core On Media Shaft
C) Thread media
D) Initialize Roll Media To Prepare For Printing
E) Select Existing Or Create New Media Parameters
When to do
This section explains how to load new media when none is currently loaded. If media
is already loaded, first read the section How to Cut and Unload Media.
Required tool
5mm hex key
Note: Check that the media is evenly rolled on the core with no bumps or extrusions.
Also check that it is aligned to avoid telescoping (lateral displacement) as it winds
onto the take-up shaft.
How to Load Media
111