Special Prints Module - Oce Arizona 200 GT User Manual

Special Prints Module

Special Prints Module
Introduction
The Special Prints sub-module displays two lists. The list on the left shows the
available special prints. Some of these prints are used by service technicians to adjust
and troubleshoot the printer. Some are of interest to the Operator: the Reference
print, the table ruler prints, the Nozzle Check print, and the Media Advance
Correction Factor print.
Special Prints of Interest to the Operator
the Reference print is used to determine that the printer output meets quality
standards. A reference print that is printed at the Océ Display Graphics Systems
factory is shipped with each printer. It can be used as a comparison with one
printed at the customer site.
The Table Rulers are meant to be printed on the table to assist you to place media.
These images are set up to print on the horizontal and vertical axes of the table.
They are available in metric or imperial measure.
The Nozzle Check is used to determine if there are any clogged nozzles that can
affect print quality (note that it is also available on the command toolbar in the
Print Job Control module).
the Media Advance Correction Factor print (used for roll media only). This print
is used to correct a certain type of banding related to incorrect media advance -
see How to Determine Media Advance Correction.
The list on the right shows all active jobs that are currently in the print queue. Add a
print from the left into the right list to make it active in the Print Job Control module.
If you remove a job from this list, it is also removed from the Active job list and is
not available to print.
70 Chapter 4 How to Navigate the User Interface