NETGEAR ProSAFE M7100-24X Reference Manual page 600

ProSAFE M7100 Managed Switches
Table 28. IP Subnet VLANS Log Messages
Component Message
IPsubnet vlans vlanIpSubnetVlanChangeCallback: Failed to
add an Entry
IPsubnet vlans vlanIpSubnetVlanChangeCallback: Failed to
delete an Entry
Table 29. Mac-based VLANs Log Messages
Component Message
Mac based VLANS MAC VLANs: Failed to save configuration
Mac based VLANS vlanMacCnfgrInitPhase1Process: Unable to
create r/w lock for vlanMac
Mac based VLANS Unable to register for VLAN change callback
Mac based VLANS vlanMacCnfgrFiniPhase1Process: could not
delete avl semaphore
Mac based VLANS vlanMacAddApply: Failed to add an entry
Mac based VLANS vlanMacDeleteApply: Unable to delete an
Entry
Mac based VLANS vlanMacVlanChangeCallback: Failed to add an
entry
Mac based VLANS vlanMacVlanChangeCallback: Failed to delete
an entry
Table 30. 802.1x Log Messages
Component Message
802.1X function: Failed calling dot1xIssueCmd
802.1X function: EAP message not received from
server
802.1X function: Out of System buffers
802.1X function: could not set state to
<authorized/unauthorized>, intf xxx
802.1X dot1xApplyConfigData: Unable to
<enable/disable> dot1x in driver
Cause
Appears when a dtl fails to add an entry for a
VLAN add notify event.
Appears when a dtl fails to delete an entry for
a VLAN delete notify event.
Cause
This message appears when save
configuration of Mac VLANs failed
Appears when a read/write lock creations
fails
Appears when this component unable to
register for VLAN change notifications
Appears when a semaphore deletion of this
component fails.
Appears when a dtl call fails to add an entry
into the table
Appears when a dtl fails to delete an entry
from the table
Appears when a dtl fails to add an entry for a
VLAN add notify event.
Appears when a dtl fails to delete an entry for
a VLAN delete notify event.
Cause
802.1X message queue is full
RADIUS server did not send required EAP
message
802.1X cannot process/transmit message
due to lack of internal buffers
DTL call failed setting authorization state of
the port
DTL call failed enabling/disabling 802.1X
Log Messages
600