Dhcp L2 Relay Agent Commands - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches
Term Definition
Ref. Port The port that carries all the mirrored traffic at the source switch.
Src RVLAN The source VLAN that is configured at the destination switch. If the remote VLAN is not
configured, this field is blank.
Dst RVLAN The destination VLAN that is configured at the source switch. If the remote VLAN is not
configured, this field is blank.
IP ACL The IP ACL ID or name that is attached to the port mirroring session.
MAC ACL The MAC ACL name that is attached to the port mirroring session.
The following is an example of the CLI command output:
(Netgear Switch) #show monitor session 1
Session Admin Probe
ID Mode Port
------- ------- ------ ------ --------- ------ ------ ----- ----- ------- -------
1 Enable 0/2

DHCP L2 Relay Agent Commands

You can enable the switch to operate as a DHCP Layer 2 relay agent to relay DHCP requests from
clients to a Layer 3 relay agent or server. The Circuit ID and Remote ID can be added to DHCP
requests relayed from clients to a DHCP server. This information is included in DHCP Option 82,
as specified in sections 3.1 and 3.2 of RFC3046.
dhcp l2relay
Use this command to enable the DHCP Layer 2 Relay agent for an interface, a range of interfaces,
or all interfaces. The subsequent commands mentioned in this section can be used only when the
DHCP L2 relay is enabled.
Format
dhcp l2relay
Modes • Global Config
• Interface Config
no dhcp l2relay
Use this command to disable the DHCP Layer 2 relay agent for an interface or range of
interfaces.
Format
no dhcp l2relay
Modes • Global Config
• Interface Config
Src Mirrored Ref.
VLAN Port Port
0/1
Switching Commands
Src Dst Type IP
RVLAN RVLAN ACL
Rx
MAC
ACL
104