NETGEAR ProSAFE M7100-24X Reference Manual page 607

ProSAFE M7100 Managed Switches
Table 46. OSPFv2 Log Messages (continued)
Component Message
OSPFv2 Dropping the DD packet because of MTU
mismatch
OSPFv2 LSA Checksum error in LsUpdate, dropping
LSID 1.2.3.4 checksum 0x1234.
Table 47. OSPFv3 Log Messages
Component Message
OSPFv3 Best route client deregistration failed for
OSPFv3 Redist
OSPFv3 Warning: OSPF LSDB is 90% full (15292
LSAs).
OSPFv3 The number of LSAs, 16992, in the OSPF
LSDB has exceeded the LSDB memory
allocation.
OSPFv3 LSA Checksum error detected for LSID
1.2.3.4 checksum 0x34f5. OSPFv3 Database
might be corrupted.
Cause
OSPFv2 ignored a Database Description
packet whose MTU is greater than the IP
MTU on the interface where the DD was
received.
OSPFv2 ignored a received link state
advertisement (LSA) whose checksum was
incorrect.
Cause
OSPFv3 registers with the IPv6 routing table
manager ("RTO6") to be notified of best
route changes. There are cases where
OSPFv3 deregisters more than once, causing
the second deregistration to fail. The failure
is harmless.
OSPFv3 limits the number of Link State
Advertisements (LSAs) that can be stored in
the link state database (LSDB). When the
database becomes 90 or 95 percent full,
OSPFv3 logs this warning. The warning
includes the current size of the database.
When the OSPFv3 LSDB becomes full,
OSPFv3 logs this message. OSPFv3
reoriginates its router LSAs with the R-bit
clear indicating that OSPFv3 is overloaded.
OSPFv3 periodically verifies the checksum of
each LSA in memory. OSPFv3 logs this.
Log Messages
607