NETGEAR ProSAFE M7100-24X Reference Manual page 402

ProSAFE M7100 Managed Switches
Parameter
interval
count
port
size
source
The following is an example of the CLI command output when the traceroute is successful:
(Netgear Switch) #traceroute 10.130.135.120 initTtl 1 maxTtl 4 maxFail 1 interval 1 count 3
port 33434 size 43
Traceroute to 10.130.135.120 ,4 hops max 43 byte packets:
1 10.130.184.1
2 10.130.0.9
3 10.130.135.120
Hop Count = 3 Last TTL = 3 Test attempt = 9 Test Success = 9
The following is an example of the CLI command output when the traceroute fails:
(Netgear Switch) #traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3 port 33434 size
43
Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:
1 10.240.4.1 19 msec
2 10.240.1.252 0 msec
3 172.31.0.9 277 msec
4 10.254.1.1 289 msec
5 10.254.21.2 287 msec
6 192.168.76.2 290 msec
7 0.0.0.0 0 msec *
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18
Description
Use the interval parameter to specify the time between probe packets, in seconds.
Range is 1–60 seconds. If a response is not received within this interval, the probe packet
is considered failed and the next probe packets is sent. If a response to the probe packet is
received within this interval, the next probe packet is sent immediately.
Use the count parameter to specify the number of probe packets to send for each TTL
value. Range is 1–10 probes.
Use the port parameter to specify destination UDP port of the probe packet. This must
be an unused port on the remote destination system. Range is 1–65,535.
Use the size parameter to specify the size, in bytes, of the payload of the probe packet.
Range is 0–65507 bytes.
Use the source parameter to specify the source IP address, interface, or loopback
interface for the traceroute.
1 ms 1 ms
1 ms 1 ms
1 ms 1 ms
18 msec 9 msec
0 msec 1 msec
276 msec
327 msec
293 msec
291 msec
Utility Commands
1 ms
1 ms
1 ms
277 msec
282 msec
296 msec
289 msec
402