NETGEAR ProSAFE M7100-24X Reference Manual page 610

ProSAFE M7100 Managed Switches
Table 55. IGMP-Proxy Log Messages
Component Message
IGMP-Proxy Error getting memory for igmp host group
record
IGMP-Proxy Error getting memory for source record
Table 56. PIM-SM Log Messages
Component Message
PIM-SM PIM-SM not initialized
PIM-SM Unable to take xxx semaphore
PIM-SM Warning : Could not send packet type xxx
(pimsm packet type) on rtrIfNum
PIM-SM add_kernel_cache : memory allocation failed
PIM_SM Config error. Trying to add static RP.
Dynamic RP with same ip addr exists
PIM-SM Inner xxx(source/group) address of register
message is invalid
Table 57. PIM-DM Log Messages
Component Message
PIM-DM Out of memory when creating xxx
PIM-DM Error entry->ll_xxx LL creation error
Cause
When we are unable to allocate memory for
the IGMP group record in the Host (Proxy)
table
When we are unable to allocate memory for
the IGMP source record in the Host (Proxy)
table
Cause
This message arises when trying to activate
pimsm interfaces or receiving pimsm packets
when pimsm component is not initialized.
This message is logged when failed to acquire
semaphore to access source list or group list
or candidate Rp list or virtual interface list.
The xxx specifies the list for which the access
is denied.
this warning is logged when failed to send a
pimsm control packet on the specified router
interface.
This message is logged when there is
insufficient memory to add a mroute entry
into cache.
Router learns RP-group mapping through
Bootstrap messages received.This message
pops when the static RP is configured which
conflicts the mapping learnt dynamically
through Bootstrap messages.
This log message appears when a register
message is received with invalid inner ip
source or group address.
Cause
This message is logged when there is
insufficient memory to accommodate a new
neighbor/(S,G) Entry, Prune, Graft, Join etc.
This message is logged when the SLL creation
is Failed.
Log Messages
610