NETGEAR ProSAFE M7100-24X Reference Manual page 376

ProSAFE M7100 Managed Switches
Term Definition
Packets • Total Packets Transmitted (Octets) - The total number of octets of data (including those
Transmitted
Octets
• Packets Transmitted 64 Octets - The total number of packets (including bad packets)
• Packets Transmitted 65-127 Octets - The total number of packets (including bad packets)
• Packets Transmitted 128-255 Octets - The total number of packets (including bad
• Packets Transmitted 256-511 Octets - The total number of packets (including bad
• Packets Transmitted 512-1023 Octets - The total number of packets (including bad
• Packets Transmitted 1024-1518 Octets - The total number of packets (including bad
• Packets Transmitted > 1518 Octets - The total number of packets transmitted that were
• Max Frame Size - The maximum size of the Info (non-MAC) field that this port will receive
• Total Packets Transmitted Successfully- The number of frames that have been transmitted
Packets
Transmitted
Successfully
• Unicast Packets Transmitted - The total number of packets that higher-level protocols
• Multicast Packets Transmitted - The total number of packets that higher-level protocols
• Broadcast Packets Transmitted - The total number of packets that higher-level protocols
Transmit Packets The number of outbound packets which were chosen to be discarded even though no errors
had been detected to prevent their being deliverable to a higher-layer protocol. A possible
Discarded
reason for discarding a packet could be to free up buffer space.
Transmit Errors • Total Transmit Errors - The sum of Single, Multiple, and Excessive Collisions.
• Tx FCS Errors - The total number of packets transmitted that had a length (excluding
• Oversized - The total number of frames that exceeded the max permitted frame size. This
• Underrun Errors - The total number of frames discarded because the transmit FIFO buffer
in bad packets) received on the network (excluding framing bits but including FCS octets).
This object can be used as a reasonable estimate of Ethernet utilization. If greater precision
is desired, the etherStatsPkts and etherStatsOctets objects should be sampled before and
after a common interval. -----
received that were 64 octets in length (excluding framing bits but including FCS octets).
received that were from 65 through 127 octets in length inclusive (excluding framing bits
but including FCS octets).
packets) received that were from 128 through 255 octets in length inclusive (excluding
framing bits but including FCS octets).
packets) received that were from 256 through 511 octets in length inclusive (excluding
framing bits but including FCS octets).
packets) received that were from 512 through 1023 octets in length inclusive (excluding
framing bits but including FCS octets).
packets) received that were from 1024 through 1518 octets in length inclusive (excluding
framing bits but including FCS octets).
longer than 1518 octets (excluding framing bits, but including FCS octets) and were
otherwise well formed.
or transmit.
by this port to its segment.
requested be transmitted to a subnetwork-unicast address, including those that were
discarded or not sent.
requested be transmitted to a Multicast address, including those that were discarded or not
sent.
requested be transmitted to the Broadcast address, including those that were discarded or
not sent.
framing bits, but including FCS octets) of from 64 through 1518 octets, inclusive, but had
a bad Frame Check Sequence (FCS) with an integral number of octets.
counter has a max increment rate of 815 counts per sec. at 10 Mb/s.
became empty during frame transmission.
Utility Commands
376