NETGEAR ProSAFE M7100-24X Reference Manual page 410

ProSAFE M7100 Managed Switches
Parameter Description
size Use the size parameter to specify the datagram size, in bytes, of the payload of the echo
requests sent. Range is 0–65,507 bytes.
source Use the source parameter to specify the source IPv6 address, interface, VLAN ID, or
network port interface to use when sending the echo requests packets. The range for vlan
is 1–4093.
quit
This command closes the current telnet connection or resets the current serial connection. The
system asks you whether to save configuration changes before quitting.
Format
quit
Modes • Privileged EXEC
• User EXEC
reload
This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should proceed.
The LEDs on the switch indicate a successful reset.
Format
reload
Mode Privileged EXEC
save
This command makes the current configuration changes permanent by writing the configuration
changes to system NVRAM.
Format
save
Mode Privileged EXEC
copy
The copy command uploads and downloads files to and from the switch. You can also use the
copy command to manage the dual images (image1 and image2) on the file system. Upload and
download files from a server by using TFTP, SFTP, SCP, or FTP. You can also upload or download
files over a USB connection.
Format
copy <source> <destination>
Mode Privileged EXEC
Utility Commands
410