Set Mld Groupmembership-Interval - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches
Note: You should enable fast-leave admin mode only on VLANs where only
one host is connected to each Layer 2 LAN port. This prevents the
inadvertent dropping of the other hosts that were connected to the
same layer 2 LAN port but were still interested in receiving multicast
traffic directed to that group.
Note: Fast-leave processing is supported only with MLD version 1 hosts.
Default disabled
Format
set mld fast-leave <vlanid>
Mode • Interface Config
• VLAN Mode
no set mld fast-leave
Use this command to disable MLD Snooping fast-leave admin mode on a selected interface.
Format
no set mld fast-leave <vlanid>
Mode • Interface Config
• VLAN Mode

set mld groupmembership-interval

Use this command to set the MLD Group Membership Interval time on a VLAN, one interface or
all interfaces. The Group Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the MLDv2 Maximum Response time value. The
range is 2 to 3600 seconds.
Default 260 seconds
Format
set mld groupmembership-interval <vlanid> <2-3600>
Mode • Interface Config
• Global Config
• VLAN Mode
Switching Commands
126