NETGEAR ProSAFE M7100-24X Reference Manual page 603

ProSAFE M7100 Managed Switches
Table 36. IPv6 Provisioning Log Message
Component Message
IPV6 Provisioning ipv6ProvIntfIsConfigurable: Error accessing
IPv6 Provisioning config data for interface
%d
Table 37. MFDB Log Message
Component Message
MFDB mfdbTreeEntryUpdate: entry does not exist
Table 38. 802.1Q Log Messages
Component Message
802.1Q dot1qIssueCmd: Unable to send message %d
to dot1qMsgQueue for vlan %d - %d msgs in
queue
802.1Q dot1qVlanCreateProcess: Attempt to create
a vlan with an invalid vlan id %d ;
VLAN %d not in range,
dot1qMapIntfIsConfigurable: Error
802.1Q
accessing DOT1Q config data for
interface %d in
dot1qMapIntfIsConfigurable.
802.1Q dot1qVlanDeleteProcess: Deleting the
default VLAN
802.1Q dot1qVlanMemberSetModify,
dot1qVlanTaggedMemberSetModify:
Dynamic entry %d can only be modified after
it is converted to static
Cause
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
pre-configuration.
Cause
Trying to update a non-existing entry
Cause
dot1qMsgQueue is full.
Accommodates for reserved vlan ids. that is,
4094 - x
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
pre-configuration.
Typically encountered during clear Vlan and
clear config
If this vlan is a learnt via GVRP then, we
cannot modify its member set via
management.
Log Messages
603