NETGEAR ProSAFE M7100-24X Reference Manual page 411

ProSAFE M7100 Managed Switches
Replace the <source> and <destination> parameters with the options that are listed in the
table on the following page. For the <url> source or destination (see the table on the following
page), use one of the following values:
tftp://{<ipaddr> | <ipv6addr> | <hostname>}/<filepath>/<filename>
sftp://{<username>@<ipaddr>| <hostname>}/<filepath>/<filename>
scp://{<username>@<ipaddr>| <hostname>}/<filepath>/<filename>
ftp://{<username>@<ipaddr>| <hostname>}/<filepath>/<filename>
usb://<filename>
Use the ias-users keyword to download the IAS user database file. When the IAS user's file is
downloaded, the switch IAS user's database is replaced with the users and their attributes in the
downloaded file.
In the copy <url> ias-users command, for <url>, use one of the following options for the
IAS user file:
tftp://{<ipaddr> | <ipv6addr> | <hostname>}/<filepath>/<filename>
sftp://<username>@<ipaddr>/<filepath>/<filename>
scp://<username>@<ipaddr>/<filepath>/<filename>
ftp://<username>@<ipaddr>/<filepath>/<filename>
usb://<filename>
The maximum length for the file path is 160 characters, and the maximum length for the file
name is 31 characters.
For TFTP, SFTP, SCP, and FTP, the <ipaddr> parameter is the IP address of the server, the
<hostname> parameter is the host name of the server, <filepath> is the path to the file, and
filename is the name of the file that you want to upload or download. For SFTP and SCP, the
<username> parameter is the user name for logging into the remote server via SSH.
Note: The <ip6addr> parameter is also a valid parameter for routing
packages that support IPv6.
For switches that support a USB device, the copy command can be used to transfer files from and
to the USB device. The syntax for the USB file is: usb://<filename>. The USB device can be
either a source or destination in the copy command. It cannot be used as both source and
destination in a copy command.
Note: Upload the existing switch CLI.cfg file off the switch before you load a
new release image in order to make a backup.
Utility Commands
411