1-Port 10-Gigabit Ethernet Spa Xfp Optical Transceiver Modules, Connectors, And Cables; Xfp Connections - Cisco ASR 1000 Series Hardware Installation Manual

Services routers sip and spa
Table of Contents

Advertisement

1-Port 10-Gigabit Ethernet SPA Overview
1-Port 10-Gigabit Ethernet SPA XFP Optical Transceiver Modules, Connectors,
and Cables
The 1-Port 10-Gigabit Ethernet SPA supports the following types of optical transceiver modules:
Cisco qualifies the optics that are approved for use with its SPAs. The above-listed small form-factor
pluggable modules (XFPs) are the only optical transceiver modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
Figure 3-13
10-Gigabit Ethernet SPA.
Figure 3-13
RX
Note
The 40-pin connector on the 1-Port 10-Gigabit Ethernet SPA is used for resilient packet ring (RPR)
connections

XFP Connections

The XFP-10GLR-OC192SR, XFP-10GER-OC192IR, and XFP-10GZR-OC192LR modules include an
optical transmitter and receiver pair integrated with Clock and Data Recovery (CDR) integrated circuits.
The XFP modules provide high-speed serial links at the rate of 10.3125 Gbps (10 Gigabit Ethernet) on
single-mode fiber (SMF). The transmit side recovers and retimes the 10-Gbps serial data and passes it
to a laser driver. The laser driver biases and modulates a 1310-nm or 1550-nm laser, enabling data
transmission over SMF through an LC connector. The receive side recovers and retimes the 10-Gbps
optical data stream from a photo detector transimpedance amplifier and passes it to an output driver.
See the label on the XFP module for technology type and model.
Table 3-8
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
3-16
Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
Single-mode very-long-reach (ZR) XFP module—XFP-10GZR-OC192LR
shows the cable type for use with the XFP optical transceiver module on the 1-Port
LC-Type Cables
TX
shows the XFP module specifications.
Chapter 3
Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
/ /
/ /
/ /
Figure 3-14
shows an XFP module and
OL-14126-15

Advertisement

Table of Contents
loading

Table of Contents