Cisco ASR 1000 Series Hardware Installation Manual page 153

Chapter 6 Installing and Removing a SPA
Note
Step 3 Install another cable clip to the other side of the SPA.
the plastic pull tab on a SPA.
Figure 6-5
1
Cable clip
Step 4 You have installed the cable clip to the SPA. Go to the next step to remove the SPA.
If attached, remove any cables from the SPA.
Step 5
To remove the SPA from the SIP, unfasten the captive installation screws on either side of the SPA.
Step 6
Figure 6-6
OL-14126-15
The cable clip is designed to easily snap into position.
Cisco ASR 1000 Series SPA with a Cable Clip Installed
illustrates how to remove a SPA in a SIP.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
Figure 6-5 shows the cable clip fully inserted into
2
1
2
SPA plastic pull tab
Removing a SPA from a SIP
6-5