Table of Contents
Advertisement
Chapter 3
Cisco 10000 Series Router Shared Port Adapters
1-Port 10-Gigabit Ethernet SPA LEDs
The 1-Port 10-Gigabit Ethernet SPA has two LEDs, an ACTIVE/LINK LED for the port and a STATUS
LED, as shown in
Figure 3-3
1
Table 3-2
Table 3-2
LED Label
ACTIVE/LINK
STATUS
1-Port 10-Gigabit Ethernet SPA XFP Optical Transceiver Modules, Connectors,
and Cables
The 1-Port 10-Gigabit Ethernet SPA supports the following types of optical transceiver modules:
•
•
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of the above-listed small
form-factor pluggable (XFPs) are the only optical transceiver modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
XFP Connections
The XFP-10GLR-OC192SR and XFP-10GER-OC192IR XFP modules include an optical transmitter
and receiver pair integrated with Clock and Data Recovery (CDR) integrated circuits. The XFP modules
provide high-speed serial links at the rate of 10.3125 Gbps (10 Gigabit Ethernet) on single-mode fiber
OL-13838-02
Figure
3-3.
1-Port 10-Gigabit Ethernet SPA Faceplate
1
ACTIVE/LINK LED
describes the 1-Port 10-Gigabit Ethernet SPA LEDs.
1-Port 10-Gigabit Ethernet SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
2
STATUS LED
State
Meaning
Off
Port is not enabled by software.
On
Port is enabled by software and the link is up.
On
Port is enabled by software and the link is down.
Off
SPA power is off.
On
SPA is ready and operational.
On
SPA power is on and good, and the SPA is being configured.
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
1-Port 10-Gigabit Ethernet SPA Overview
SPA-1X10GE-L-V2
2
3-17
Advertisement
Table of Contents
