Oc-192 Module Connections - Cisco ASR 1000 Series Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA supports the following types of optical transceiver
modules:
•
•
•
Cisco Systems qualifies the optics that are approved for use with its SPAs.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
Figure 3-36
OC-192c/STM-64 POS/RPR XFP SPA.
Figure 3-36
RX

OC-192 Module Connections

Table 3-32
SPA.
Table 3-32 OC-192 Specifications
Specification
Wavelength
Cabling distance (maximum)
Operating case temperature range
Tx power
Receiver sensitivity (maximum)
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
3-54
Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
Single-mode very-long reach (LR) XFP module—XFP-10GZR-OC192LR
shows the cable type for use with the XFP optical transceiver module on the 1-Port
LC-Type Cable for the XFP Optical Transceiver Modules
TX
shows the OC-192 specifications for use with the 1-Port OC-192c/STM-64 POS/RPR XFP
Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
/ /
/ / / /
Description
OC-192 SR-1: 1290 nm to 1330 nm
OC-192 IR-2: 1530 nm to 1565 nm
OC-192 LR-2: 1530 nm to 1565 nm
OC-192 SR-1: 2 km (1.2 miles)
OC-192 IR-2: 40 km (24.8 miles)
OC-192 LR-2: 50 miles (80 km)
OC-192 SR-1: 23 to 158
OC-192 IR-2: 23 to 158
OC-192 LR-2: 23 to 158
OC-192 SR-1: –6 dBm –1 dBm
OC-192 IR-2: –1 dBm +2 dBm
OC-192 LR-2: 0 to +4 dBm
OC-192 SR-1: –11 dBm
OC-192 IR-2: –14 dBm
OC-192 LR-2: –24 dBm
o o
F (–5 to 70 C)
o o
F (–5 to 70 C)
o o
F (–5 to 70 C)
OL-14126-15