Installing And Removing A Sip; Handling Sips - Cisco ASR 1000 Series Hardware Installation Manual

Installing and Removing a SIP

This chapter describes how to install or remove SIPs on the Cisco ASR 1000 Series Aggregation Services
Routers. This chapter contains the following sections:
•
•
•

Handling SIPs

Each SIP circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD)
damage. See the
Before you begin installation, read
and tools required for installation.
Always handle the SIP by the carrier edges and handle; never touch the SIP components or connector
Caution
pins. (See
When a slot is not in use, a blank filler plate must be installed in the empty slot to allow the router or
switch to conform to electromagnetic interference (EMI) emissions requirements and to allow proper
airflow across the installed modules. If you plan to install a SIP in a slot that is not in use, you must first
remove the blank filler plate.
OL-14126-15
Handling SIPs, page 5-1
Online Insertion and Removal, page 5-2
SIP Installation and Removal, page 5-9
"Preventing Electrostatic Discharge Damage" section on page 4-8
Figure 5-1.)
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
C H A P T E R
Chapter 4, "Preparing to Install a SIP or a SPA,"
5
for ESD precautions.
for a list of parts
5-1