Cisco ASR 1000 Series Hardware Installation Manual page 142

Online Insertion and Removal
Enter the show facility-alarm status command. The following example shows a critical alarm that is
generated when a SPA is removed from the system:
Router# show facility-alarm status
System Totals
Source
------
subslot 1/1
Note A critical alarm "Active Card Removed OIR Alarm" is generated even if a SPA is removed after
performing graceful deactivation.
Choosing the Mode of the hw-module subslot Command
You can deactivate a SPA and all of its interfaces by using the hw-module subslot command in one of
two modes:
•
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
5-6
Critical: 1
Severity
--------
CRITICAL
If you choose to use the hw-module subslot shutdown command in global configuration mode, you
change the configuration so that no matter how many times the router is rebooted, the SPA will not
boot. This command is useful when you need to shut down a SPA in a remote location and ensure
that it does not come back up if the router is rebooted.
If you choose to use the hw-module subslot stop command in EXEC mode, you cause the SPA to
gracefully shut down. However, the SPA will come up again when executing the hw-module subslot
start command.
Major: 0 Minor: 0
Description [Index]
-------------------
Active Card Removed OIR Alarm [0]
Chapter 5 Installing and Removing a SIP
OL-14126-15