2-Port Copper And Optical Gigabit Ethernet Spa Cables, Connectors, And Pinouts; Sfp Module Connections; Cables, Connectors, And Pinouts - Cisco ASR 1000 Series Hardware Installation Manual

Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
Table 3-10
LED Label
2-Port Copper and Optical Gigabit Ethernet SPA Cables, Connectors, and
Pinouts
The 2-Port Copper and Optical Gigabit Ethernet SPA has two individual fiber-optic receivers that
support SFP modules. Each port can send and receive traffic using the optical fiber connections.

SFP Module Connections

The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet ports on the 2-Port Copper and Optical Gigabit Ethernet SPA, linking the port with a fiber-optic
network.
The 2-Port Copper and Optical Gigabit Ethernet SPA will only accept the SFP modules listed as
Note
supported in this document. An SFP module check is run every time an SFP module is inserted into the
2-Port Copper and Optical Gigabit Ethernet SPA and only SFP modules that pass this check will be
usable by the 2-Port Copper and Optical Gigabit Ethernet SPA.
SFP modules exist for technologies other than Gigabit Ethernet and for products other than the 2-Port
Copper and Optical Gigabit Ethernet SPA. However, the information in this document pertains only to
SFP modules that plug into the 2-Port Copper and Optical Gigabit Ethernet SPA ports.
See the
SFP module options, module specifications, and cabling specifications.
For CWDM and DWDM SFP module specifications, see the
Gigabit Ethernet SPAs" section on page

Cables, Connectors, and Pinouts

In addition to the two fiber-optic receivers, the 2-Port Copper and Optical Gigabit Ethernet SPA has two
individual RJ-45 receptacles. You can use both interface connectors simultaneously. Each connection
supports IEEE 802.3 and Ethernet 10/100BASE-T interfaces compliant with appropriate standards.
Cisco does not supply Category 5 unshielded twisted pair (UTP) RJ-45 cables; these cables are available
commercially.
Figure 3-16
OL-14126-15
2-Port Copper and Optical Gigabit Ethernet SPA LEDs (continued)
Color State
Green On
Amber On
"SFP Module and Cabling Specifications for Gigabit Ethernet SPAs" section on page 3-25
shows the RJ-45 connector.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
Meaning
SPA is ready and operational.
SPA power is on and good, and SPA is being configured.
"CWDM and DWDM SFP Modules for
3-29.
Table 3-11 lists the pinouts and signals for the RJ-45 connector.
2-Port Gigabit Ethernet SPA Overview
for
3-19