Packing A Sip For Shipment - Cisco ASR 1000 Series Hardware Installation Manual

Packing a SIP for Shipment

Packing a SIP for Shipment
This section provides step-by-step instructions for packing a SIP for shipment. Before beginning this
procedure, you should have the following original Cisco packaging materials:
•
•
•
•
•
•
For information on removing a SIP, see the
Note
The Cisco original packaging is to be used for the shipment of all SIPs. Failure to properly use Cisco
Caution
packaging can result in damage or loss of a product.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card.
Caution
See
These instructions assume that the SIP has been removed from the router according to the recommended
Note
procedures specified in this guide.
To pack a SIP for shipment, see
Insert the SIP into the static shielding bag. (Not shown in diagram.)
Step 1
Step 2 Place the bottom support into the smaller inner carton.
Place the bagged SIP onto the bottom support.
Step 3
Place the corrugated spacer on top of the bagged SIP.
Step 4
Close the smaller inner carton and tape the sides closed.
Step 5
Place the sealed smaller inner carton containing the SIP into the two foam packing cushions (the carton
Step 6
only fits one way).
Place the sealed smaller inner carton and packing cushions into the larger exterior carton, and seal the
Step 7
larger exterior carton with tape for shipment.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
7-20
Static shielding bag
Corrugated spacer
Bottom support
Smaller inner carton
Two foam packing cushions
Larger exterior carton
Preventing Electrostatic Discharge Damage, page 4-8
"SIP Installation and Removal" section on page
Figure 7-2, and perform the following steps:
Chapter 7 Troubleshooting the Installation
for information about preventing ESD.
5-9.
OL-14126-15