1-Port 10-Gigabit Ethernet Spa Leds; 1-Port 10-Gigabit Ethernet Spa Xfp Optical Transceiver Modules, Connectors, And Cables; Figure 2-9 1-Port 10-Gigabit Ethernet Spa Faceplate; Table 2-11 1-Port 10-Gigabit Ethernet Spa Leds - Cisco 12000 - Series Chassis Modular Expansion Base Hardware Installation Manual

Router sip and spa
Hide thumbs Also See for 12000 - Series Chassis Modular Expansion Base:
Table of Contents

Advertisement

Chapter 2
Overview: Cisco 12000 Series Router Shared Port Adapters

1-Port 10-Gigabit Ethernet SPA LEDs

The 1-Port 10-Gigabit Ethernet SPA has two LEDs, an ACTIVE/LINK LED for the port and a STATUS
LED, as shown in
Figure 2-9
1
Table 2-11

Table 2-11 1-Port 10-Gigabit Ethernet SPA LEDs

LED Label
ACTIVE/LINK
STATUS
1-Port 10-Gigabit Ethernet SPA XFP Optical Transceiver Modules, Connectors,
and Cables
The 1-Port 10-Gigabit Ethernet SPA supports the following types of optical transceiver modules:
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of the above listed small
form-factor pluggable (XFPs) are the only optical transceiver modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
Figure 2-10
10-Gigabit Ethernet SPA.
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Figure
2-9.
1-Port 10-Gigabit Ethernet SPA Faceplate
1
ACTIVE/LINK LED
describes the 1-Port 10-Gigabit Ethernet SPA LEDs.
Color
Off
Green
Amber
Off
Green
Amber
Single-mode short-reach (SR) XFP module—XFP-10GLR
Single-mode intermediate-reach (IR) XFP module—XFP-10GER
Single-mode long-reach (LR) XFP module—XFP-10GZR
shows the cable type for use with the XFP optical transceiver module on the 1-Port
2
STATUS LED
State
Meaning
Off
Port is not enabled by software.
On
Port is enabled by software and the link is up.
On
Port is enabled by software and the link is down.
Off
SPA power is off.
On
SPA is ready and operational.
On
SPA power is on and good, and the SPA is being configured.
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
1-Port 10-Gigabit Ethernet SPA Overview
SPA-1X10GE-L-V2
2
2-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gsr12/60-rf - 12012 router

Table of Contents