Table of Contents
Advertisement
NOTICE OF REVISIONS
The following information in this Operation Guide should be revised as
indicated.
1 Addition before step 3 on the left side of page 9-7
IMPORTANT!
If there is any paper jammed further inside the copier,
pull the drawer[cassette] out and remove the jammed paper.
2 Addition to "1. If one of the following messages is
displayed" on page 9-1
The following error message and corresponding procedure should be
added to this section.
Message
"Reset feeding unit for paper drawer."
["Reset feeding unit for pap.cassette."]
Procedure
Pull out both drawers[cassettes] No.3 and No.4 and push the Paper
Feeder Unit securely all the way into the copier. (See step 7 on page 9-8.)
3 Revision to the right side of page 8-6
The following revision should be made to the information below.
(The new information is indicated in italics.)
6 Stacking mode
If the number of copies that is ejected onto
copying in the Non-sort mode reaches the acceptable limit (max:
201st
all copies from the
onward will be ejected onto
Tray B
during large volume
200
),
Tray A
.
4 Addition to "(1) Note when adding paper" on the left side
of page 3-1
IMPORTANT!
Using special paper
In this copier, the type of paper loaded in each drawer[cassette] and on
the multi-bypass tray can be specified under "Paper type
(drawer[cassette] No.1 - No. 5)" on page 7-24 and "(1) Paper size and
type" on page 7-60, respectively.
Among the special paper that can be use with this copier, there is a wide
range in paper quality and construction especially in those types of paper
noted below. For that reason, there is a greater possibility of problems
occurring during copying with these type of paper. Whenever you do use
such special paper as noted here, it is recommended that you first make
a test copy and verify the results.
<Special paper for which extra caution is recommended>
• Preprinted
• Label sheets*1
• Prepunched
*1: When using label sheets, be absolutely certain that there is no
possibility that the backing glue will come into contact with any part of
the copier, and that none of the labels will come off the sheet during
copying. If glue does happen to come into contact with the drum or
rollers, or one of the labels comes off inside the copier, it can be the
cause of major damage.
Advertisement
Table of Contents
