Table of Contents
Advertisement
Section 9 TROUBLESHOOTING
4 Misfeed in the Duplex Unit
("JAM 51" or "JAM 60" through "JAM 68")
If one of the messages above is displayed, a misfeed has occurred in
the Duplex Unit. Perform the following procedure to remove the
jammed paper.
Inch specifications
Paper misfeed.
JAM 00
Metric specifications
Paper misfeed.
JAM 00
1
Open the front cover.
2
Turn the green conveyor knob A to the left at least 7 full turns
and remove the jammed paper.
A
3
Push the green release lever (B) down to the left.
B
9-14
1.Remove paper from duplex unit.
2.Open upper cover and remove paper.
3.Loosen 2-green screws are on rear side of
the duplex unit and open the guide plate.
4.Remove paper.
5.Close cover and reset duplex unit.
1.Remove paper from duplex unit.
2.Open upper cover and remove paper.
3.Remove 2 green screws on rear side of
the duplex unit and open the guide plate.
4.Remove paper.
5.Close cover and reset duplex unit.
4
Turn the green conveyor knob (C) to the left at least 4 full
turns.
WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.
5
Pull the paper conveyor unit out towards you as far as it will
go.
6
Remove the jammed paper
C
Advertisement
Table of Contents
