If Paper Jams; Cautions; Removal Procedures - Olivetti d-Copia 45 Operation Manual

Section 9 TROUBLESHOOTING

3. If paper jams

If a paper misfeed occurs, copying will stop and a message will appear on the touch panel about the misfeed. Leave the main switch ON ( | ) and
refer to "(2) Removal procedures" to remove the jammed paper.
Inch specifications
Paper misfeed.
JAM 00

(1) Cautions

WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove any loose scraps
of paper from inside the copier, or they could cause another misfeed
later.
* Once misfed paper has been removed, warm-up will begin, the
misfeed indication will go out, and the copier will return to the same
settings prior to the misfeed.
* If a misfeed occurs in the Document Finisher, it is not necessary to
add the misfed copy to the other copies that are already ejected into
the tray, as that copy will be automatically made again.

(2) Removal procedures

1 Misfeed in a paper feed area
Misfeed in drawer[cassette] No.1 or drawer[cassette] No.2
("JAM 10" or "JAM 11")
If one of the messages above is displayed, a misfeed has occurred in
the indicated drawer[cassette]. Perform the following procedure to
remove the jammed paper.
9-6
1.Open front cover.
Metric specifications
Paper misfeed.
1.Open front cover.
JAM 00
Inch specifications
Paper misfeed.
JAM 00
Metric specifications
Paper misfeed.
JAM 00
1 First, open the right cover and check if there is any jammed
paper. If there is any jammed paper inside that cover,
remove it.
2 Pull out the drawer[cassette] currently being used.
1.Open right cover, and remove paper.
2.Open paper drawer 1.
3.Remove paper.
4.Set the drawer, and close the cover.
1.Open right cover, and remove paper.
2.Open paper cassette 1.
3.Remove paper.
4.Set the cassette, and close the cover.