Table of Contents
Advertisement
IMPORTANT!
DO NOT set more originals than indicated on the sticker that is
attached to the rear original insert guide. If more than the acceptable
number of originals is set, the originals may not feed properly.
(2) Setting originals on the platen
To make copies from originals that cannot be set in the Document
Processor (books, magazines, etc.), lift open the Document
Processor and set one original at a time on the platen.
1
Hold the Document Processor handle and lift the Document
Processor open.
* Before opening the Document Processor, remove any
originals that are on the original table and the original eject
table to prevent them from falling off the Document
Processor when it is opened.
2
Set the original face down on the platen and align it with the
appropriate original size indicator lines on the left side of the
platen.
Section 3 PREPARATIONS
3
Hold the Document Processor handle and close the
Document Processor.
* Leave the Document Processor open whenever you are
using an original that is over 4 cm thick.
IMPORTANT!
Avoid placing excessive pressure on the platen when closing the
Document Processor. Too much pressure on the platen may cause
the glass to break.
NOTE
When copying from open-faced originals (books, etc.), shadows may
appear around the outside edges of, or up the middle between, the
copy images.
CAUTION
DO NOT leave the document processor open as
there is a danger of personal injury.
3-7
Advertisement
Table of Contents
