Mounting The Realpresence Collaboration Server (Rmx) 4000 In A 23" Rack - Polycom DOC2709A Hardware Manual

When the unit is installed on a rack, the rack must be properly grounded to the central office ground.
The rack must be grounded with two-hole compression-type connectors using copper conductors
(tinned or untinned). Wire, bus bar or braided strap connectors are acceptable.
Mounting the RealPresence Collaboration Server (RMX) 4000 in a 23"
Rack
1
2
3
4
Rack mounting screws must be supplied by the rack's manufacturer.
Polycom, Inc.
The airflow of the RMX 4000 is from right to left. Be sure that the areas on the left and
right side of the system are clear for proper ventilation.
Mounting the RMX 4000 on a 23" rack requires that first the handles and then the 19"
brackets be removed from the MCU. This is shown in Figure 1-9.
Figure 1-9 Removing and attaching 19" and 23" brackets
After removal, attach the 23" brackets as provided in the Rack Installation Accessories kit,
and re-install the handles to the 23" brackets. This is shown in Figure 1-10.
Figure 1-10Installing the handles and brackets & detailed rear view of 23" bracket attachment
Mount the RMX on top of the rack brackets using the blades or place it on a rack mount
shelf with chassis runners.
Fasten the RMX to the rack with 8 screws into the holes provided on the RMX's front as
shown in Figure 1-8.
Chapter 1-Hardware Description
1-15